How to choose the best air aftertreatment system?

As we have already mentioned, compressed air can be processed from dirty, greasy, and humid to dry, clean, and oil-free air, many times cleaner than the ambient air we breathe. However, as air quality improves, so does the cost. This fee can take many forms: Increased cost of capital equipment Increased maintenance costs Increased energy costs Dryer energy consumption (electric or compressed air) Pressure drop (requires the compressor to use more power to overcome the losses) 1. Determine the required air quality In order to help facility engineers and OEMs specify the compressed air quality of solid particles, humidity and oil, the International Organization for Standardization (ISO) has formulated ISO 8573.1:2010. Air quality is expressed in XYZ, where X is the particulate level, Y is the humidity (moisture) level, and Z is the oil, as shown in the following table. If there are no specifications for installed equipment, some guidelines are as follows: Typical manufacturing and woodworking facilities using pneumatic tools, cylinders, blow-casting and CNC machines typically require liquid water to eliminate and reduce particulate and oil content (ISO 8573.1: Class 2010 2.4.2). This can be solved by using a refrigerated air dryer and a general purpose coalescing filter. Manufacturing in cold environments and unheated spaces will require a lower moisture dew point to prevent moisture and line icing (ISO 8573.1: Class 2010 2.2.2). This can be solved by a desiccant dryer with a coalescing pre-filter and a particle post-filter, or by a membrane dryer with a coalescing pre-filter if the demand is low. Laser cutting of ferrous metals usually requires low moisture and oil content (ISO 8573.1:2010 class 1.2.1). This requires a desiccant or membrane dryer with a particle filter, an ultrafine coalescing filter and a vapor filter. Laser cutting of certain thicknesses of stainless steel may require the use of nitrogen or other protective gases instead of compressed air. This can be generated from compressed air by using a membrane nitrogen generator or a pressure swing adsorption (PSA) nitrogen generator. The instrument air requirement pressure dew point shall not be less than 18 °F below the minimum temperature to which any part of the instrument air system is subjected in any season in accordance with Instrument Society of America (ISA) Standard 7.0.0.01-1996. In no case shall it exceed 35 °F. The particle level is limited to 3 microns and the oil content does not exceed 1 part per million by weight. This puts the instrument air at ISO 8573.1:2010 Class 2. 3. In most cases, a desiccant dryer with a coalescing prefilter and a particulate postfilter, or a membrane dryer with a coalescing prefilter is required. In fully heated equipment, this requirement can almost be met by ISO 8573.1:2010 class 2.

11

2024

/

03

< 1...121314...25 >